Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to follow the correct removal and installation procedures for the occupant classification ECU.



1. CHECK OCCUPANT CLASSIFICATION ECU (VEHICLE NOT INVOLVED IN COLLISION)
  1. Perform a diagnostic system check (Click here).



2. CHECK OCCUPANT CLASSIFICATION ECU (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for the following defects of the occupant classification ECU:

    1. Cracks on the ECU housing
    2. Dents on the ECU housing
    3. Chips on the ECU housing
    4. Cracks or other damage to the connector
    5. Damage to the serial number

    OK:
    No defects are found.

    HINT:
    If any of the defects is found, replace the occupant classification ECU with a new one.



3. CHECK OCCUPANT CLASSIFICATION ECU (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for the following defects of the occupant classification ECU:

    1. Cracks on the ECU housing
    2. Dents on the ECU housing
    3. Chips on the ECU housing
    4. Cracks or other damage to the connector
    5. Damage to the serial number

    OK:
    No defects are found.

    HINT:
    If any of the defects is found, replace the occupant classification ECU with a new one.