Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH

POWER WINDOW MASTER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B240255
  1. Detach the 2 clips to remove the front door lower frame bracket garnish LH.



2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH


    B240256E01
  1. Using a moulding remover, detach the 3 claws to remove the No. 2 door inside handle bezel LH as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B353477
  1. Detach the 4 claws to remove the 2 door armrest caps.



    B353478
  1. Remove the 3 screws.

  1. Detach the 11 clips.



    B353479E01
  1. Pull out the front door trim board sub-assembly LH in the direction indicated by the arrow shown in the illustration.

  1. Raise the front door trim board sub-assembly LH and detach the 4 claws and reference boss to remove the front door trim board sub-assembly LH together with the front door inner glass weatherstrip LH.
    Text in Illustration 
    *1
    Reference Boss



    B240574
  1. Disconnect the connector.



    B238525
  1. Disconnect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH.



4. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH


    B238526
  1. Using a screwdriver, detach the 4 claws to remove the front door inner glass weatherstrip LH from the front door trim board sub-assembly LH as shown in the illustration.



5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY


    B242305
  1. Disconnect the connector.



    B240577
  1. Detach the 10 claws from the backside and remove the multiplex network master switch with base panel.



    B241709
  1. Remove the 3 screws and multiplex network master switch assembly.