REAR POWER WINDOW SWITCH > INSTALLATION |
| 1. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY |
Attach the 2 claws to install the power window regulator switch assembly to the base panel.
Connect the connector.
Attach the 10 claws to the install the power window regulator switch with base panel.
| 2. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH |
![]() |
Attach the 3 claws to install the rear door inner glass weatherstrip LH as shown in the illustration.
| 3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
![]() |
Attach the claw to install the clamp.
![]() |
Connect the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH as shown in the illustration.
![]() |
Connect the connector.
![]() |
Attach the rear door trim board sub-assembly LH to the 4 claws of the rear door inner glass weatherstrip LH as shown in the illustration.
Attach the reference boss.
| *1 | Reference Boss |
![]() |
Attach the 9 clips to install the rear door trim board sub-assembly LH.
Install the 3 screws.
![]() |
Attach the 4 claws to install the 2 door armrest caps.
| 4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH |
![]() |
Attach the 3 claws to install the rear door inside handle bezel LH.