Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY (for Magnet Clutch Control)

RELAY (for Magnet Clutch Control) > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE MAGNET CLUTCH RELAY


    E200936E01
  1. Remove the magnet clutch relay from the engine room relay block.
    Text in Illustration 
    *1
    Magnet Clutch Relay



2. INSPECT MAGNET CLUTCH RELAY


B060778E97
  1. Measure the resistance of the according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminal 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.



3. INSTALL MAGNET CLUTCH RELAY
  1. Install the magnet clutch relay to the engine room relay block.