Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY (w/ PTC Heater)

RELAY (w/ PTC Heater) > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE PTC HEATER RELAY (PTC NO. 1, PTC NO. 1, PTC NO. 3)


    E200937E01
  1. Remove the 3 PTC heater relays from the engine room relay block.
    Text in Illustration 
    *1
    PTC No. 1 Relay
    *2
    PTC No. 2 Relay
    *3
    PTC No. 3 Relay



2. INSPECT PTC HEATER RELAY (PTC NO. 1, PTC NO. 2, PTC NO. 3)


A092673E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminal 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.



3. INSTALL PTC HEATER RELAY (PTC NO. 1, PTC NO. 2, PTC NO. 3)
  1. Install the 3 PTC heater relays to the engine room relay block.