OIL PUMP > DISASSEMBLY |
| 1. REMOVE AUTOMATIC TRANSMISSION CASE O-RING |
![]() |
Remove the O-ring from the oil pump assembly.
| 2. FIX OIL PUMP ASSEMBLY |
![]() |
Place the oil pump body on the torque converter clutch.
| *1 | Torque Converter Clutch |
| 3. REMOVE CLUTCH DRUM OIL SEAL RING |
![]() |
Remove the 3 oil seal rings.
| 4. REMOVE STATOR SHAFT ASSEMBLY |
![]() |
Remove the 14 bolts and stator shaft from the oil pump body.
| 5. REMOVE FRONT OIL PUMP BODY O-RING |
![]() |
Remove the O-ring from the oil pump body.
Remove the oil pump body from the torque converter clutch.
| 6. INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the oil pump body bush.
| 7. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the stator shaft bush.
| 8. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() |
Push the driven gear to one side of the body.
Using a feeler gauge, measure the body clearance.
![]() |
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.
![]() |
Using a steel straightedge and feeler gauge, measure the side clearance of both gears.
| Mark | Thickness |
| 0 | 10.74 to 10.749 mm (0.42283 to 0.42319 in.) |
| 1 | 10.75 to 10.759 mm (0.42323 to 0.42358 in.) |
| 2 | 10.76 to 10.77 mm (0.42362 to 0.42401 in.) |
| 3 | 10.771 to 10.78 mm (0.42405 to 0.42441 in.) |
| 4 | 10.781 to 10.79 mm (0.42445 to 0.42480 in.) |
| 9. REMOVE FRONT OIL PUMP DRIVE GEAR |
![]() |
| 10. REMOVE FRONT OIL PUMP DRIVEN GEAR |
![]() |
| 11. REMOVE FRONT OIL PUMP OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal.