Home › Drivetrain ยท A750F AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    D027961E06
  1. Using SST and a hammer, tap in a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    Make sure the oil seal end is flush with the outer edge of the pump body.

  1. Coat the lip of the oil seal with MP grease.



2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D027959E01
  1. Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D027958E01
  1. Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.



5. INSTALL FRONT OIL PUMP BODY O-RING


    D027963E03
  1. Coat a new O-ring with ATF and install it to the oil pump body.
    Text in Illustration 
    *1
    New O-Ring



6. INSTALL STATOR SHAFT ASSEMBLY


    D027953E01
  1. Align the bolt holes of the stator shaft with the bolt holes of the oil pump body and install the stator shaft to the oil pump body.

  1. Install the 14 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



7. INSTALL CLUTCH DRUM OIL SEAL RING


    D027952E07
  1. Coat 3 new oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.

    NOTICE:
    Do not excessively widen the rings.



8. INSPECT OIL PUMP DRIVE GEAR ROTATION


D027962E01
  1. Place the oil pump body on the torque converter clutch.

  1. Check that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter clutch.



9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING


    D027950E04
  1. Coat a new O-ring with ATF and install it to the oil pump assembly.
    Text in Illustration 
    *1
    New O-Ring