Home › Drivetrain · A750F AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)


C214326E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    ATF Temperature
    Specified Condition
    2 (OT-) - 10 (OT+)
    10°C (50°F)
    5 to 8 kΩ
    2 (OT-) - 10 (OT+)
    25°C (77°F)
    2.5 to 4.5 kΩ
    2 (OT-) - 10 (OT+)
    110°C (230°F)
    0.22 to 0.28 kΩ
    1 (OT2-) - 9 (OT2+)
    10°C (50°F)
    5 to 8 kΩ
    1 (OT2-) - 9 (OT2+)
    25°C (77°F)
    2.5 to 4.5 kΩ
    1 (OT2-) - 9 (OT2+)
    110°C (230°F)
    0.22 to 0.28 kΩ

    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Wire)

    HINT:
    If the resistance is out of the specified range at one of the ATF temperatures shown in the table below the driveability of the vehicle may decrease.

    Resistance (Reference):
    ATF Temperature
    Specified Condition
    10°C (50°F)
    5 to 8 kΩ
    25°C (77°F)
    2.5 to 4.5 kΩ
    110°C (230°F)
    0.22 to 0.28 kΩ

    If the result is not as specified, replace the transmission wire.