REAR VIEW MONITOR SYSTEM (for Navigation Receiver Type) > TERMINALS OF ECU |
| REAR TELEVISION CAMERA ASSEMBLY |

Disconnect the Y2 rear television camera assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| Y2-6 (CB+) - Y2-5 (CGND) | R - BR | Power source | Within 60 seconds of turning the ignition switch to ACC | 5.5 to 7.05 V |
| Y2-5 (CGND) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Reconnect the Y2 rear television camera assembly connector.
Check for pulses between each terminal of the connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| Y2-2 (CV-) - Y2-3 (CV+) | B - W | Video signal | Ignition switch ON Shift lever in R Camera lens not covered, displaying an image | Pulse generation (See waveform 1) |
| Ignition switch ON Shift lever in R Camera lens covered, blacking out screen | Pulse generation (See waveform 2) |
![]() |
Reference (Oscilloscope waveform):
Waveform 1 (camera lens is not covered, displaying an image)
| Item | Content |
| Terminal No. (Symbol) | Y2-2 (CV-) - Y2-3 (CV+) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Ignition switch ON, shift lever in R |
Waveform 2 (camera lens is covered, blacking out the screen)
| Item | Content |
| Terminal No. (Symbol) | Y2-2 (CV-) - Y2-3 (CV+) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Ignition switch ON, shift lever in R |
| *a | Waveform 1 (camera lens is not covered, displaying an image) |
| *b | Waveform 2 (camera lens is covered, blacking out the screen) |
| *c | Synchronization Signal |
| *d | Video Waveform |
| NAVIGATION RECEIVER ASSEMBLY (Click here) |