Home › Drivetrain · VF2A TRANSFER / 4WD / AWD › TRANSFER INDICATOR SWITCH

TRANSFER INDICATOR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT TRANSFER INDICATOR SWITCH (4WD POSITION)


G034535
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    1 - 2
    Not pushed
    100 kΩ or higher

    If the resistance is not as specified, replace the switch.



2. INSPECT TRANSFER INDICATOR SWITCH (L4 POSITION)


G034535
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    1 - 2
    Not pushed
    100 kΩ or higher

    If the resistance is not as specified, replace the switch.



3. INSPECT TRANSFER INDICATOR SWITCH (NEUTRAL POSITION)


C217344
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    1 - 2
    Not pushed
    100 kΩ or higher

    If the resistance is not as specified, replace the switch.