Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR

COMPRESSOR > INSPECTION

for Preparation Click here



1. INSPECT MAGNET CLUTCH ASSEMBLY


E195722E01
  1. Check the magnet clutch operation.

    1. Confirm that the magnet clutch hub and magnet clutch rotor lock when the positive (+) lead of the battery is connected to terminal 3 of the magnet clutch, and the negative (-) lead is connected to the ground wire.
      If the operation is not as specified, replace the magnet clutch assembly.
      Text in Illustration 
      *1
      Magnet Clutch Rotor
      *2
      Magnet Clutch Hub
      *3
      Battery
      *a
      Component without harness connected
      (Magnet Clutch Assembly)

  1. Measure the resistance between terminals 1 and 2.

    Standard resistance:
    65 to 125 Ω at 20°C (68°F)

    If the result is not as specified, replace the cooler compressor assembly.