TRANSFER ASSEMBLY > INSPECTION |
| 1. INSPECT TRANSFER INPUT SHAFT |
![]() |
Using a micrometer, measure the outer diameter of the input shaft journal surface.
![]() |
Using a dial indicator, measure the inside diameter of the input shaft bushing.
| 2. INSPECT SYNCHRONIZER RING |
![]() |
Turn the ring and confirm that the input shaft and synchronizer ring are engaged with each other.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring and the input shaft spline.
| 3. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance of the planetary pinion gear.
| 4. INSPECT PLANETARY PINION GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the planetary pinion gear.
| 5. INSPECT TRANSFER REAR OUTPUT SHAFT |
![]() |
Using a micrometer, measure the outer diameter of the output shaft rear journal surface.
| 6. INSPECT DRIVE SPROCKET RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance between the sprocket and the shaft with the needle roller bearing installed.
| 7. INSPECT NO. 1 TRANSFER GEAR SHIFT FORK AND FRONT DRIVE CLUTCH SLEEVE CLEARANCE |
![]() |
Using a vernier caliper, measure the thickness of the No. 1 transfer gear shift fork claw.
Using a vernier caliper, measure the width of the groove of the front drive clutch sleeve.
Calculate the clearance between the front drive clutch sleeve and No. 1 transfer gear shift fork.
| 8. INSPECT NO. 2 TRANSFER GEAR SHIFT FORK AND TRANSFER HIGH AND LOW CLUTCH SLEEVE CLEARANCE |
![]() |
Using a vernier caliper, measure the thickness of the No. 2 transfer gear shift fork claw.
Using a vernier caliper, measure the width of the groove of the transfer high and low clutch sleeve.
Calculate the clearance between the high and low clutch sleeve and No. 2 transfer gear shift fork.