Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY

FRONT DRIVE SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP
  1. Hold the drive shaft lightly in a vise between aluminum plates.



    C108564
  1. Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration.



2. REMOVE FRONT NO. 1 AXLE INBOARD JOINT BOOT CLAMP
  1. Remove the front axle inboard joint boot clamp.

    HINT:
    Perform the same procedures as for the front No. 2 axle inboard joint boot clamp.



3. REMOVE FRONT AXLE INBOARD JOINT BOOT


4. REMOVE FRONT AXLE INBOARD JOINT SET


    FA01615E05
  1. Place matchmarks on the tripod and the inboard and outboard joint shafts.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.



    G022501
  1. Using a snap ring expander, remove the snap ring.



    N000194E14
  1. Place matchmarks on the outboard joint shaft and tripod.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, remove the tripod from the drive shaft.

    NOTICE:
    Do not tap the roller.



5. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP


    C063445
  1. Using a screwdriver, remove the outboard joint boot clamps.

    HINT:
    If the outboard joint boot clamps that have been replaced are installed to the drive shaft, use a side cutter to remove them.



6. REMOVE FRONT NO. 1 AXLE OUTBOARD JOINT BOOT CLAMP


C081566
  1. Using pliers, remove the boot clamp, as shown in the illustration.



7. REMOVE OUTBOARD JOINT BOOT


8. REMOVE SHAFT SNAP RING


C057543
  1. Using a screwdriver, remove the snap ring.



9. REMOVE FRONT DRIVE SHAFT DUST COVER


F040647E01
  1. Using SST and a press, remove the dust cover.

    SST
    09950-00020