Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB (for 2WD)

FRONT AXLE HUB (for 2WD) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


    F043120
  1. Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

    HINT:
    Use a container to catch brake fluid as it drains out.



    F043121
  1. Remove the 2 bolts and disc brake cylinder assembly.



3. REMOVE FRONT DISC


    C215913E01
  1. Place matchmarks on the disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the front disc.



4. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


C216258
  1. Remove the 4 bolts, axle hub and disc brake dust cover from the steering knuckle.

  1. Remove the O-ring from the axle hub.