Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB (for 4WD)

FRONT AXLE HUB (for 4WD) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


    F043120
  1. Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

    HINT:
    Use a container to catch brake fluid as it drains out.



    F043121
  1. Remove the 2 bolts and disc brake cylinder assembly.



3. REMOVE FRONT DISC


    C215913E01
  1. Place matchmarks on the disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the front disc.



4. REMOVE FRONT AXLE HUB GREASE CAP
  1. Using a screwdriver and hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



5. REMOVE FRONT AXLE SHAFT NUT


    F042732
  1. Remove the cotter pin and lock cap.

  1. Remove the front axle shaft nut.



6. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


F042759E01
  1. Remove the 4 bolts.

  1. Using a plastic-faced hammer, tap out the front drive shaft from the front axle hub.

    NOTICE:
    Be careful not to damage the drive shaft boot.

  1. Remove the front axle hub and front disc dust cover.

  1. Remove the O-ring.