HYDRAULIC BRAKE BOOSTER > REASSEMBLY |
| 1. INSTALL BRAKE BOOSTER PISTON SIB-ASSEMBLY |
![]() |
Apply a light coat of lithium soap base glycol grease to a new piston.
Install the piston.
Install the piston.
Using 2 screwdrivers, install a new snap C-ring while pressing in the piston.
| 2. INSTALL MASTER CYLINDER BOOT |
| 3. INSTALL MASTER CYLINDER PUSH ROD CLEVIS |
Install the brake master cylinder side lock nut and rod operating adapter to the brake master cylinder.
Install the lock nut and master cylinder push rod clevis to the rod operating adapter.
| 4. INSTALL MASTER CYLINDER SOLENOID |
Install a new gasket.
Install the master cylinder solenoid with 6 new bolts.
| 5. INSTALL BRAKE BOOSTER ACCUMULATOR PIPE |
Install the brake booster accumulator pipe and compression spring.
Install a new O-ring to the brake booster accumulator assembly.
Install the brake booster accumulator assembly.
| 6. INSTALL NO. 3 BRAKE ACTUATOR BRACKET |
Install the No. 3 brake actuator bracket.
| 7. INSTALL NO. 1 BRAKE BOOSTER PUMP BRACKET |
Install the brake booster pump bush to the No. 1 brake booster pump bracket.
Using a 5 mm hexagon wrench, install the No. 1 brake booster pump bracket with the 2 bolts.
| 8. INSTALL BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY |
Using a 4 mm hexagon wrench, install the 2 pins to the brake master cylinder.
Install 2 new brake booster pump collars and 2 brake booster pump bushes to the brake booster with accumulator pump assembly.
Install the brake booster with accumulator pump assembly to the brake master cylinder.
![]() |
Install a new clip.
![]() |
Connect the wire harnesses with the 2 screws.
| *1 | Red Cable |
| *2 | Black Cable |
Install 2 new plugs.
| 9. INSTALL NO. 1 BRAKE ACTUATOR TUBE |
Using a union nut wrench, install the No. 1 brake actuator tube.
| 10. INSTALL NO. 1 BRAKE ACTUATOR HOSE |
Using needle nose pliers, install the brake actuator hose with the 2 clips.
| 11. INSTALL MASTER CYLINDER RESERVOIR GROMMET |
![]() |
Apply a light coat of lithium soap base glycol grease to 3 new reservoir grommets.
Install the 3 reservoir grommets to the brake master cylinder.
| 12. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY |
Install the brake master cylinder reservoir sub-assembly with the screw.
Install the master cylinder reservoir filler cap.
Using a pin punch and hammer, install a new pin to the brake master cylinder reservoir sub-assembly.
| 13. INSTALL NO. 1BRAKE ACTUATOR BRACKET |
Install the brake fluid level warning switch connector to the No. 1 brake actuator bracket.
Using a 5 mm hexagon wrench, install the No. 1 brake actuator bracket with the bolt.