Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU

HINT:
Inspect the connector from the back side.


E129452E41

  1. Disconnect the F7 ECU connector.

  2. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    F7-7 (IG) - F7-9 (GND)
    G - W-B
    IG power source
    Ignition switch ON
    11 to 14 V

  3. Connect the F7 ECU connector.

  4. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    F7-2 (SPD) - F7-9 (GND)
    SB - W-B
    Vehicle speed signal
    Vehicle being driven
    Pulse generation
    (see waveform 1)
    F7-3 (TC) - F7-9 (GND)
    R - W-B
    TC terminal
    Terminal TC not connected
    11 to 14 V
    F7-4 (TACH) - F7-9 (GND)
    P - W-B
    Engine speed signal
    Engine running
    Pulse generation (see waveform 2)
    F7-5 (IND) - F7-9 (GND)
    G - W-B
    Tire pressure warning light output signal
    After ignition switch turned to ON, tire pressure warning light illuminates for 3 seconds
    0.9 to 3.2 V
    Ignition switch ON
    Tire pressure warning light off
    3.2 V or higher
    F7-6 (RF5V) - F7-9 (GND)
    LG - W-B
    Tire pressure warning antenna and receiver power source
    Ignition switch ON
    4.5 to 5.5 V
    F7-9 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    F7-10 (SIL) - F7-9 (GND)
    G - W-B
    Diagnosis tester communication line
    Ignition switch ON
    Communication not performed with tester
    11 to 14 V
    F7-11 (GND2) - F7-9 (GND)
    GR - W-B
    Tire pressure warning antenna and receiver ground
    Always
    Below 1 Ω
    F7-12 (RDA) - F7-9 (GND)
    SB - W-B
    Tire pressure warning antenna and receiver signal
    Ignition switch ON
    11 to 14 V



  5. F047507E05
  6. Using an oscilloscope, check waveform 1.
    Item
    Contents
    Terminal No. (Symbol)
    F7-2 (SPD) - F7-9 (GND)
    Tool Setting
    5 V/DIV., 200 ms/DIV.
    Vehicle Condition
    Vehicle being driven at approximately 20 km/h (12 mph)

    HINT:
    The wavelength becomes shorter as the vehicle speed increases.



  7. F047507E05
  8. Using an oscilloscope, check waveform 2.
    Item
    Contents
    Terminal No. (Symbol)
    F7-4 (TACH) - F7-9 (GND)
    Tool Setting
    5 V/DIV., 10 ms/DIV.
    Vehicle Condition
    Idling

    HINT:
    The wavelength becomes shorter as the engine speed increases.