Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light.

WIRING DIAGRAM


C171960E02

HINT:
When each warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced (Click here).

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
  1. Disconnect the F7 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F7-3 (TC) - F13-13 (TC)
    Always
    Below 1 Ω
    F7-3 (TC) - Body ground
    Always
    10 kΩ or higher
    F13-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK

CHECK ECU POWER SOURCE CIRCUIT (Click here)