Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the switch signals using the AVC-LAN.
If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM


E226159E47


INSPECTION PROCEDURE

NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

HINT:
The navigation receiver assembly is the master unit.

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E221758E21
  1. Disconnect the G37 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G37-7 (TX1+) - G37-8 (TX1-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Navigation Receiver Assembly)



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
  1. Disconnect the G37 navigation receiver assembly connector.

  1. Disconnect the N11 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N11-8 (TX+) - G37-7 (TX1+)
    Always
    Below 1 Ω
    N11-7 (TX-) - G37-8 (TX1-)
    Always
    Below 1 Ω
    N11-8 (TX+) - Body ground
    Always
    10 kΩ or higher
    N11-7 (TX-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

    OK:
    Master unit returns to normal operation.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

REPLACE MALFUNCTIONING PARTS