POWER STEERING SYSTEM > Power Steering Warning Light Circuit |

| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check for DTCs of the CAN communication system (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the F41 power steering ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F41-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F41-3 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (METER/GAUGE SYSTEM) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Perform the Active Test of the combination meter using the Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| PPS Indicator | Power steering warning light | ON or OFF | Perform the test with the vehicle stopped and the engine idling. |
Check that the power steering warning light operates in accordance with the Active Test.
|
| ||||
| OK | ||
| ||