OIL COOLER > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts.
![]() |
Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.
| 2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY |
Remove the 4 bolts and rear engine under cover assembly.
| 3. REMOVE FRONT FENDER APRON SEAL RH |
Remove the 4 clips and front fender apron seal RH.
| 4. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL RH |
Remove the 5 clips and front No. 1 fender apron to frame seal RH.
| 5. REMOVE NO. 1 OIL COOLER INLET HOSE AND NO. 1 OIL COOLER OUTLET HOSE |
![]() |
Detach the claw to open the No. 1 flexible hose clamp.
Disconnect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the No. 2 oil cooler tube.
Disconnect the 2 hoses from the oil cooler inlet tube and No. 1 oil cooler outlet tube and remove them.
| 6. REMOVE NO. 1 OIL COOLER INLET TUBE AND NO. 1 OIL COOLER OUTLET TUBE |
![]() |
Using a union nut wrench, disconnect the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube from the each oil cooler tube union.
Remove the 2 bolts to open the 2 No. 2 flexible hose clamps and remove the 2 oil cooler tubes.
Remove the 2 bolts and 2 No. 2 flexible hose clamps.
| 7. REMOVE NO. 2 OIL COOLER INLET HOSE AND NO. 2 OIL COOLER OUTLET HOSE |
![]() |
Disconnect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose from the radiator.
Disconnect the 2 hoses from the No. 2 oil cooler tube and remove them.
| 8. REMOVE NO. 2 OIL COOLER TUBE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and No. 2 oil cooler tube.