Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD

AUTOMATIC RUNNING BOARD > INSPECTION

for Preparation Click here



1. INSPECT SIDE AUTO STEP MOTOR ASSEMBLY


    B295789E01
  1. Check that the motor gear rotates smoothly as follows.

    NOTICE:
    Do not apply positive (+) battery voltage to any terminals except terminal 5 and 4 to avoid damaging the pulse sensor inside the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 5
    Battery negative (-) → 4
    Motor gear rotates counterclockwise (Deploying)
    Battery positive (+) → 4
    Battery negative (-) → 5
    Motor gear rotates clockwise (Stowing)

    1. If the result is not as specified, replace the side auto step motor assembly.

    CAUTION:
    Reset the side auto step motor assembly (initialize the pulse sensor) after installing the side auto step motor assembly and side auto step assembly.

    Text in Illustration 
    *1
    Motor Gear
    *a
    Component without harness connected
    (Side Auto Step Motor Assembly)
    *b
    Clockwise (Stowing)
    *c
    Counterclockwise (Deploying)