Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SWITCH

AUTOMATIC RUNNING BOARD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SIDE AUTO STEP SWITCH ASSEMBLY


    B295367E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (CTY1) - 4 (ECU1)
    AUTO
    Below 1 Ω
    OFF
    10 kΩ or higher
    5 (CTY2) - 6 (ECU2)
    AUTO
    Below 1 Ω
    OFF
    10 kΩ or higher

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 7 (ILL+)
    Battery negative (-) → Terminal 2 (ILL-)
    LED illuminates