REAR BRAKE FLEXIBLE HOSE > INSTALLATION |
| 1. INSTALL NO. 5 FLEXIBLE HOSE BRACKET |
Install the bracket with the bolt.
| 2. INSTALL NO. 6 FLEXIBLE HOSE BRACKET |
Install the bracket with the bolt.
| 3. INSTALL REAR FLEXIBLE HOSE |
Connect the rear flexible hose to the connecting point with each brake tube, and then install 2 new clips.
Using a union nut wrench, connect each brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.
Connect the rear flexible hose to the connecting point with each brake tube, and then install 2 new clips.
Using a union nut wrench, connect each brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.
| 4. INSTALL REAR FLEXIBLE HOSE LH |
Connect the rear flexible hose to the connecting point with the brake tube, and then install a new clip.
Using a union nut wrench, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.
Install the rear flexible hose and a new gasket to the rear disc brake cylinder with the union bolt.
| 5. BLEED BRAKE LINE |
Turn the engine switch on (IG).
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.
Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.
Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
Turn the engine switch off (IG).
Inspect for brake fluid leaks.
Check and adjust the brake fluid level .
| 6. INSTALL REAR WHEEL |