Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE REAR FLEXIBLE HOSE LH


    F043125
  1. Remove the union bolt, gasket and rear flexible hose from the rear disc brake cylinder.



    C214597
  1. Disconnect the brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip.



4. REMOVE REAR FLEXIBLE HOSE


    C217124
  1. Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

  1. Remove the 2 clips.

  1. Remove the rear flexible hose.



    C217125
  1. Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

  1. Remove the 2 clips.

  1. Remove the rear flexible hose.



5. REMOVE NO. 5 FLEXIBLE HOSE BRACKET


    C217154
  1. Remove the bolt and bracket from the upper arm bracket.



6. REMOVE NO. 6 FLEXIBLE HOSE BRACKET
  1. Remove the bolt and bracket from the rear axle housing.