Drive the vehicle slowly at 8 km/h (5 mph) or less in a circle. If there is not enough space to drive in a circle, turn the car around in the following manner, doing two three-point turns in succession. After driving in 1 to 3 circles in the above method, calibration is completed when the direction is shown on the display.
- HINT:
- Do not perform calibration of the compass in a place where the earth's magnetic field is subject to interference by artificial magnetic fields (in an underground parking lot, under a steel tower, between buildings, in a parking lot on a roof, near a crossing, near a large vehicle, etc.).
- During calibration, do not operate electrical systems (sliding roof, power windows, etc.) as they may interfere with the calibration.
- The dot on the compass display disappears when calibration is completed.