Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Air Conditioning Control Panel Circuit

for Preparation Click here


DESCRIPTION

This circuit consists of the heater control assembly and air conditioning amplifier assembly. When the heater control assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate when the heater control assembly is operated.

WIRING DIAGRAM


E157369E26


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (HEATER CONTROL - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the F42 amplifier connector.

  1. Disconnect the F29 control connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F29-10 (LIN1) - F42-37 (LIN1)
    Always
    Below 1 Ω
    F29-10 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (HEATER CONTROL - BATTERY AND BODY GROUND)
E200500E01
  1. Disconnect the F29 control connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F29-4 (IG+) - F29-11 (GND)
    Ignition switch off
    Below 1 V
    F29-4 (IG+) - F29-11 (GND)
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F29-11 (GND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Heater Control Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE HEATER CONTROL ASSEMBLY
  1. Replace the heater control assembly with a new or normally functioning one (Click here).

  1. Operate the heater control assembly to check that it functions properly.

    OK:
    Heater control assembly operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (HEATER CONTROL ASSEMBLY IS FAULTY)