AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > Air Conditioning Control Panel Circuit |

| 1.CHECK HARNESS AND CONNECTOR (HEATER CONTROL - AIR CONDITIONING AMPLIFIER) |
Disconnect the F42 amplifier connector.
Disconnect the F29 control connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F29-10 (LIN1) - F42-37 (LIN1) | Always | Below 1 Ω |
| F29-10 (LIN1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HEATER CONTROL - BATTERY AND BODY GROUND) |
![]() |
Disconnect the F29 control connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F29-4 (IG+) - F29-11 (GND) | Ignition switch off | Below 1 V |
| F29-4 (IG+) - F29-11 (GND) | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F29-11 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Heater Control Assembly) |
|
| ||||
| OK | |
| 3.REPLACE HEATER CONTROL ASSEMBLY |
Replace the heater control assembly with a new or normally functioning one (Click here).
Operate the heater control assembly to check that it functions properly.
|
| ||||
| OK | ||
| ||