KINETIC DYNAMIC SUSPENSION SYSTEM > TERMINALS OF ECU |

| *a | Component with harness connected (Stabilizer Control ECU) | - | - |
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| F70-1 (SLAL) - Body ground | LG - Body ground | Stabilizer control solenoid valve output signal (for Upper Chamber) | Ignition switch ON Vehicle stopped | Below 1 V |
| F70-3 (SLAU) - Body ground | P - Body ground | Stabilizer control solenoid valve output signal (for Lower Chamber) | Ignition switch ON Vehicle stopped | Below 1 V |
| F70-6 (SGP1) - Body ground | G - Body ground | Pressure sensor ground | Always | Below 1 V |
| F70-15 (SBP1) - Body ground | R - Body ground | Power source (Pressure sensor) | Ignition switch ON | 4.75 to 5.25 V |
| F70-17 (SOP1) - Body ground | GR - Body ground | Pressure sensor input signal | Ignition switch ON | 0.4 to 4.6 V |
| F70-22 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| F70-24 (IG) - Body ground | B - Body ground | Power source | Ignition switch ON | 11 to 14 V |
| F70-28 (CANL) - F70-29 (CANH) | W - P | CAN communication line | Ignition switch off | 54 to 69 Ω |