Home › Power Source / Network › 1GR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY CAP


    A219656
  1. Using a screwdriver, remove the generator pulley cap.



2. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Mount the generator in a vise between aluminum plates.



    A219555E01
  1. Install SST (A) and SST (B) to the generator with clutch pulley as shown in the illustration.

    SST
    09820-63021  
    Text in Illustration 
    *1
    Rotor Shaft

    NOTICE:
    Securely attach SST to the generator with clutch pulley and generator rotor shaft.



    A219556E01
  1. Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator.

  1. Remove the generator with clutch pulley from the rotor shaft.



3. REMOVE GENERATOR REAR END COVER


    A221621
  1. Remove the nut and cord clip.



    A220458
  1. Remove the 3 nuts and generator rear end cover.



4. REMOVE TERMINAL INSULATOR


    A219659
  1. Remove the terminal insulator from the generator coil.



5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A219660
  1. Remove the 2 screws and brush holder from the generator coil.



6. REMOVE GENERATOR COIL ASSEMBLY


    A219661
  1. Remove the 4 bolts.



    A219662E01
  1. Using SST, remove the generator coil assembly.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn



7. REMOVE GENERATOR ROTOR ASSEMBLY


    A118365E01
  1. Remove the generator washer.



    A219665
  1. Remove the generator rotor assembly.



8. INSPECT GENERATOR DRIVE END FRAME BEARING


    A128080
  1. Check that the drive end frame bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.



9. REMOVE GENERATOR DRIVE END FRAME BEARING


    A223426
  1. Remove the 4 screws and retainer plate from the drive end frame.



    A128077E01
  1. Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)