Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Front Side)

WASHER NOZZLE (for Front Side) > ADJUSTMENT

for Preparation Click here



1. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E199009E01
  1. Using a screwdriver, detach the 2 claws and disconnect the washer nozzle sub-assembly as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Be careful not to damage the windshield.



    E201314
  1. Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.



2. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the washer fluid spray area is as specified in On-vehicle Inspection. Replace the washer nozzle with the selected one.


    E179763E04


    Text in Illustration 
    *1
    Available Washer Nozzles
    *2
    Washer Fluid Spray Angle
    *3
    Part Number
    -
    -



3. INSTALL WASHER NOZZLE SUB-ASSEMBLY
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E199010
  1. Attach the 2 claws to install the washer nozzle sub-assembly.