Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH

DOWNHILL ASSIST CONTROL SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL DOWNHILL ASSIST CONTROL SWITCH


    C208934
  1. Attach the 2 claws to install the downhill assist control switch to the map lamp assembly.

  1. Connect the 2 connectors.



2. INSTALL MAP LIGHT ASSEMBLY
  1. Attach the 2 clips to install the map light assembly.

  1. Install the screws.



3. INSTALL DRIVE MONITOR SWITCH
  1. Connect the connector.

  1. Attach the 4 claws to install the drive monitor switch (CRAWL control switch and multi-terrain select switch).



4. PERFORM DOWNHILL ASSIST CONTROL CALIBRATION
  1. Perform downhill assist control switch calibration (Click here).