Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH

DOWNHILL ASSIST CONTROL SWITCH > REMOVAL

for Preparation Click here



1. REMOVE DRIVE MONITOR SWITCH


    B352852
  1. Detach the 4 claws and remove the drive monitor switch (CRAWL control switch and multi-terrain select switch) from the map light assembly.

  1. Disconnect the connector.



2. REMOVE MAP LIGHT ASSEMBLY


    C216443
  1. Remove the screws.

  1. Detach the 2 clips and remove the map light assembly.



3. REMOVE DOWNHILL ASSIST CONTROL SWITCH


    C208928E01
  1. Disconnect the 2 connectors.



    C208931
  1. Using a screwdriver, detach the 2 claws and remove the downhill assist control switch from the map light assembly.

    HINT:
    Tape the screwdriver tip before use.