FRONT BRAKE > INSTALLATION |
| 1. INSTALL FRONT DISC |
Align the matchmarks and install the front disc.
| 2. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH |
Install the disc brake cylinder assembly with the 2 bolts.
Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.
| 3. INSTALL FRONT NO. 1 ANTI-SQUEAL SHIM |
Install the front No. 1 anti-squeal shims to the front disc brake pads.
| 4. INSTALL FRONT DISC BRAKE PAD |
Install the 2 front disc brake pads to the disc brake cylinder.
Install the anti-rattle spring between the 2 front disc brake pads.
Install the 2 hole pins.
Install the pin hold clip.
| 5. BLEED BRAKE LINE |
Turn the engine switch on (IG).
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.
Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.
Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
Turn the engine switch off (IG).
Inspect for brake fluid leaks.
Check and adjust the brake fluid level .
| 6. INSTALL FRONT WHEEL |