Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > INSPECTION

for Preparation Click here



1. CHECK BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust or scoring.
    If necessary, replace the disc brake cylinder assembly.



2. CHECK PAD LINING THICKNESS


    F042679
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    11.3 mm (0.445 in.)

    Minimum thickness:
    1.0 mm (0.0394 in.)

    If the pad lining thickness is less than the minimum, replace the pad.



3. CHECK DISC THICKNESS


    F042680
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    32.0 mm (1.26 in.)

    Minimum thickness:
    29.0 mm (1.14 in.)

    If the disc thickness is less than the minimum, replace the disc.



4. CHECK DISC RUNOUT


    C191821
  1. Install the disc with the 6 hub nuts.

    Torque:
    112 N*m{ 1137 kgf*cm , 82 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.

    Maximum disc runout:
    0.05 mm (0.00197 in.)

    If the disc runout is more than the maximum, check the bearing play in the axial direction and the axle hub runout . If the bearing play and axle hub runout are normal, adjust the disc runout or grind the disc using an "On-car" brake lathe.

  1. Remove the 6 hub nuts and disc.