Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off the brake fluid immediately if it comes into contact with a painted surface.



3. REMOVE FRONT DISC BRAKE PAD


    C215909E04
  1. Remove the pin hold clip.
    Text in Illustration 
    *1
    Hole Pin
    *2
    Pin Hold Clip
    *3
    Anti-rattle Spring

    NOTICE:
    The pin hold clip can be reused if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.

  1. Remove the 2 hole pins.



    C170925
  1. Remove the front disc brake anti-rattle spring.

    NOTICE:
    The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.



    C170926
  1. Remove the 2 front disc brake pads from the disc brake cylinder.

  1. Remove the front No. 1 anti-squeal shims from each pad.



4. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


    F043120
  1. Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

    HINT:
    Use a container to catch brake fluid as it drains out.



    F043121
  1. Remove the 2 bolts and disc brake cylinder assembly.



5. REMOVE FRONT DISC


    C215913E01
  1. Place matchmarks on the disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the front disc.