Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE CYLINDER BOOT


    F043127
  1. Using a screwdriver, remove the cylinder boot from the rear disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE REAR DISC BRAKE PISTON


    F043128
  1. Place a cloth or equivalent between the rear disc brake piston and rear disc brake cylinder.

  1. Use compressed air to remove the rear disc brake piston from the rear disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.



3. REMOVE PISTON SEAL


    C213453
  1. Using a screwdriver, remove the piston seal from the rear disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the rear disc brake bleeder plug cap and rear disc brake bleeder plug from the rear disc brake cylinder.