Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH

PARKING BRAKE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARKING BRAKE SWITCH ASSEMBLY


    C217121
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Switch connector - Switch body
    On (Shaft is not pressed)
    Below 1 Ω
    Off (Shaft is pressed)
    10 kΩ or higher

    Text in Illustration 
    V100135
    On
    V100136
    Off
    If the result is not as specified, replace the parking brake switch assembly.