Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Door Mirror Foot Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU controls the door mirror foot light.

WIRING DIAGRAM


E200973E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (DOOR MIRROR FOOT LIGHT)
  1. Using the Techstream, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Side Mirror Foot Light
    Door mirror foot light
    ON/OFF
    -

    OK:
    Door mirror foot light comes on.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (OUTER MIRROR - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the I4 and H4 outer mirror connectors.

  1. Disconnect the F10 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    I4-1 (MLP) - F10-4 (MILE)
    Always
    Below 1 Ω
    I4-7 (MLP-) - Body ground
    Always
    Below 1 Ω
    I4-1 (MLP) - Body ground
    Always
    10 kΩ or higher
    for RH:
    Tester Connection
    Condition
    Specified Condition
    H4-1 (MLP) - F10-4 (MILE)
    Always
    Below 1 Ω
    H4-7 (MLP-) - Body ground
    Always
    Below 1 Ω
    H4-1 (MLP) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)