Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT

BACK DOOR SUPPORT > DISPOSAL

for Preparation Click here



1. DISPOSE OF BACK DOOR DAMPER STAY SUB-ASSEMBLY LH
  1. Secure the back door damper stay sub-assembly horizontally in a vise with the piston rod pulled out.



    B246353E01
  1. Wear safety glasses. Using a metal saw, slowly cut a groove between A and B shown in the illustration to release the gas.

    Standard:
    Area
    Measurement
    A - B
    100 mm (3.94 in.)
    B - C
    30 mm (1.18 in.)

    CAUTION:
    Although the gas inside the back door damper stay sub-assembly is colorless, odorless and harmless, metal debris may scatter. Therefore, cover the back door damper stay sub-assembly with a piece of cloth or other material.