Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT

BACK DOOR SUPPORT > INSTALLATION

for Preparation Click here



1. INSTALL BACK DOOR UPPER DAMPER STAY BRACKET LH


    B240239E01
  1. Install the back door upper damper stay bracket with the 2 bolts.

    HINT:
    Tighten the bolts in the order shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. INSTALL BACK DOOR STAY BOLT
  1. Clean the threaded portion on the vehicle body with a non-residue solvent.

  1. Apply adhesive to the threads of the bolt.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    B240247
  1. Install the back door stay bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



3. INSTALL BACK DOOR DAMPER STAY SUB-ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the door damper stay.



    B240240
  1. Install a new back door damper stay sub-assembly.

    NOTICE:
    1. Install the back door damper stay sub-assembly while supporting the back door by hand.
    2. Check that the back door stay assembly is attached to the ball joint and that the back door damper stay sub-assembly cannot be pulled out.