Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT

BACK DOOR SUPPORT > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR DAMPER STAY SUB-ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the door damper stay.



    B242503E01
  1. Using a screwdriver, remove the stop ring along the groove.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. Release the ball joint and remove the back door damper stay sub-assembly.

    NOTICE:
    Remove the back door damper stay sub-assembly while supporting the back door by hand.



2. REMOVE BACK DOOR STAY BOLT


    B240247
  1. Remove the back door stay bolt.

    NOTICE:
    If the hood support is detached from the ball joint, it becomes non-reusable. Therefore, do not detach the hood support from the ball joint unless replacing it.



3. REMOVE BACK DOOR UPPER DAMPER STAY BRACKET LH


    B240239
  1. Remove the 2 bolts and back door upper damper stay bracket.