Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH

STOP LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    E233306E14
  1. Disconnect the connector from the stop light switch assembly.

  1. Measure the voltage according to the value (s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A47-7 (B) - A47-2 (GND)
    Ignition switch off
    11 to 14 V
    A47-6 (B) - A47-2 (GND)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stop Light Switch Assembly)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A47-2 (GND) - Body ground
    Always
    Below 1 Ω



    E233300E17
  1. Reconnect the connector to the stop light switch assembly.

  1. Measure the voltage according to the value (s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A47-1 (OUT) - A47-2 (GND)
    Ignition switch off, brake pedal not depressed
    Below 1 V
    A47-1 (OUT) - A47-2 (GND)
    Ignition switch off, brake pedal depressed
    11 to 14 V
    A47-3 (L) - A47-2 (GND)
    Ignition switch off, brake pedal not depressed
    Below 1 V
    A47-4 (ACC) - A47-2 (GND)
    Ignition switch off
    11 to 14 V
    A47-3 (L) - A47-2 (GND)
    Ignition switch off, brake pedal depressed
    11 to 14 V
    A47-5 (L) - A47-2 (GND)
    Ignition switch ON, brake pedal not depressed
    11 to 14 V
    A47-5 (L) - A47-2 (GND)
    Ignition switch ON, brake pedal depressed
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Stop Light Switch Assembly)
    If the result is not as specified, replace the stop light switch assembly.