Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here


NOTICE:
Be sure to read the precaution before performing this procedure (Click here).

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE LOWER FRONT BUMPER COVER
  1. Remove the clip, 5 bolts and front lower bumper cover.



3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



4. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY


    C214451
  1. Remove the 6 bolts and 2 member braces from the front frame assembly.



5. REMOVE FRONT STABILIZER END BRACKET (w/ KDSS)


    C214452
  1. Remove the 4 bolts and 2 brackets from the lower arm.



6. REMOVE FRONT STABILIZER BAR (w/ KDSS)


    F047879
  1. Remove the 4 bolts, 2 front stabilizer lower brackets and front stabilizer bar.

  1. Remove the 2 front stabilizer link bushes and front stabilizer lower bracket bushes from the front stabilizer bar.



7. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH (w/o KDSS)


    C099158
  1. Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



8. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH (w/o KDSS)

HINT:
Use the same procedure described for the LH side.



9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH (w/o KDSS)


    G020162
  1. Remove the 2 bolts and front No. 1 stabilizer bracket LH.



10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH (w/o KDSS)

HINT:
Use the same procedure described for the LH side.



11. REMOVE FRONT STABILIZER BAR (w/o KDSS)


12. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/ REAS)

NOTICE:
Perform this procedure with the vehicle jacked up so that all the shock absorbers are extended.



    G020404E02
  1. As shown in the illustration, loosen the nut and disconnect the tube.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    NOTICE:
    Never loosen the absorber hoses or the flare nuts at the joint parts.



    G020405
  1. Remove the bolt and bracket.



    C099159
  1. Remove the bolt, nut and washer.



    C099160
  1. Remove the 3 nuts on the top of the front shock absorber with coil spring.



13. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/o REAS)


    C099159
  1. Remove the bolt, nut and washer.



    C099160
  1. Remove the 3 nuts on the top of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.