Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR (w/o KDSS)

FRONT STABILIZER BAR (w/o KDSS) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT STABILIZER BAR


2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH


    G021678E05
  1. Install the 2 front No. 1 stabilizer bar bushes.

    HINT:
    1. Install the bush to the inner side of the bushing stopper on the stabilizer bar.
    1. Install the No. 1 stabilizer bush with the protrusion facing inward.

    Text in Illustration 
    *1
    Bushing Stopper
    *a
    Vehicle Outer Side
    *b
    Vehicle Front Side
    V100135
    Protrusion



3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
  1. Install the front No. 1 stabilizer bracket LH with the 2 bolts.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Use the same procedure described for the LH side.



5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the front stabilizer link assembly LH with the 2 nuts.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



7. INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY
  1. Install the 2 member braces with the 6 bolts.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }



8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    A224743
  1. Hook the No. 1 engine under cover sub-assembly to the vehicle body as shown in the illustration.

  1. Install the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



9. INSTALL LOWER FRONT BUMPER COVER
  1. Install the front lower bumper cover with the 5 bolts and clip.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



10. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }