Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR (w/o KDSS)

FRONT STABILIZER BAR (w/o KDSS) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE LOWER FRONT BUMPER COVER
  1. Remove the clip, 5 bolts and front lower bumper cover.



3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



4. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY


    C214451
  1. Remove the 6 bolts and 2 member braces from the front frame assembly.



5. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


    G020161
  1. Remove the 2 nuts and front stabilizer link assembly LH.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



6. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



7. REMOVE FRONT NO. 1 STABILIZER BRACKET LH


    G020162
  1. Remove the 2 bolts and front No. 1 stabilizer bracket LH.



8. REMOVE FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Use the same procedure described for the LH side.



9. REMOVE FRONT NO. 1 STABILIZER BAR BUSH
  1. Remove the 2 front No. 1 stabilizer bar bushes.



10. REMOVE FRONT STABILIZER BAR