Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (w/o KDSS)

REAR STABILIZER BAR (w/o KDSS) > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    D028258
  1. Remove the nut and disconnect the stabilizer bar from the stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



    D028259
  1. Hold the stabilizer bar link with a wrench and remove the nut, retainer, cushion and link.

  1. Remove the 2 retainers and cushion from the stabilizer link.



3. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



4. REMOVE REAR STABILIZER BAR


    D028260
  1. Remove the 4 bolts, 2 stabilizer brackets and stabilizer bar.

  1. Remove the 2 stabilizer bushes from the stabilizer bar.