Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (w/o KDSS)

REAR STABILIZER BAR (w/o KDSS) > INSPECTION

for Preparation Click here



1. INSPECT REAR STABILIZER LINK ASSEMBLY


    D028478
  1. As shown in the illustration, flip the ball joint stud back and forth 5 times.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take a torque reading on the 5th turn.

    Standard turning torque:
    0.05 to 1.96 N*m (0.51 to 20 kgf*cm, 0.44 to 17.3 in.*lbf)