Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK

BACK DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR LOCK ASSEMBLY


B237422E01
  1. Set the back door lock to the full-latch position.

  1. Apply battery voltage to the door motor connector and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1 (ACT+)
    Battery negative (-) → 4 (ACT-)
    Moves to open-latch position

    1. If the result is not as specified, replace the back door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (E) - 2 (S)
    Open-latch
    Below 1 Ω
    3 (E) - 2 (S)
    Full-latch
    10 kΩ or higher

    1. If the result is not as specified, replace the back door lock assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Lock Assembly)
    *b
    Full-latch
    *c
    Open-latch