Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › TRACTION OFF SWITCH

TRACTION OFF SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL TRACTION CONTROL SWITCH (A-TRAC SWITCH)


    C208933
  1. Attach the 2 claws to install the traction control switch (A-TRAC switch) to the map light assembly.

  1. Connect the 2 connectors.



2. INSTALL MAP LIGHT ASSEMBLY
  1. Attach the 2 clips to install the map light assembly.

  1. Install the screws.



3. INSTALL DRIVE MONITOR SWITCH
  1. Connect the connector.

  1. Attach the 4 claws to install the drive monitor switch (CRAWL control switch and multi-terrain select switch).